Hi All
I bought the following USBASP programmer from Ebay. http://www.ebay.co.uk/itm/370532286436? ... 1439.l2649
Can I ask if it will be ok to you on my 9x please. If so I was going to start the soldering later today and leave the 10pin block plug flush with the casing so this unit plugs into it. Then use a short USB extension to plug it into the PC will this be ok..
If this is OK I will get on with it then I ill have to find out what drivers I need later when all done and put back together..
Many thanks for your help
Regs Os
Programmer Will this be OK?
- ShowMaster
- Posts: 4327
- Joined: Thu Dec 29, 2011 3:44 am
- Country: -
- Location: Los Angeles, CA USA
Re: Programmer Will this be OK?
I've been using this OK one so maybe you can compare voltages and ect.
http://www.hobbyking.com/hobbyking/stor ... duct=21321
http://www.hobbyking.com/hobbyking/stor ... duct=21321
-
- 9x Developer
- Posts: 1109
- Joined: Sat Dec 31, 2011 12:11 am
- Country: -
- Location: Massa (MS), Tuscany, Italy
Re: Programmer Will this be OK?
Yes it is... you can use originan usbasp drivers with it
Re: Programmer Will this be OK?
Thanks Romolo
At least I know im ok to continue to solder Also will it be ok to use the short USB extension I was on about.
Also which is the best diagram for showing all the contacts and pads? I have a couple but still not shure I keep switching on the solder station then off again then rechecking. Stupid aint it seeing iv built ham radios and been inside and mended others But its different Dont ask why LOL...
Os
At least I know im ok to continue to solder Also will it be ok to use the short USB extension I was on about.
Also which is the best diagram for showing all the contacts and pads? I have a couple but still not shure I keep switching on the solder station then off again then rechecking. Stupid aint it seeing iv built ham radios and been inside and mended others But its different Dont ask why LOL...
Os
Re: Programmer Will this be OK?
Hi All
Can anyone point me to a set of the original USBASP Drivers that has all the files needed for setup included inc the sys and the dll please. Many thanks iv been hunting and found them but most have the dll missing.
regs Os
Can anyone point me to a set of the original USBASP Drivers that has all the files needed for setup included inc the sys and the dll please. Many thanks iv been hunting and found them but most have the dll missing.
regs Os
Re: Programmer Will this be OK?
Thanks again Romolo
Iv got the driver all installed and iv downloaded eePe for the flashing Thats alright is it not?
I just need to do the soldering now..
Thanks Os
Iv got the driver all installed and iv downloaded eePe for the flashing Thats alright is it not?
I just need to do the soldering now..
Thanks Os
-
- 9x Developer
- Posts: 1109
- Joined: Sat Dec 31, 2011 12:11 am
- Country: -
- Location: Massa (MS), Tuscany, Italy
Re: Programmer Will this be OK?
For er9x eepe is great, for other firmwares you may have a look to companion9x too