Hello!
i helped my friend with new firmware for his Turnigu 9xr, installed er9x -r818, is that wrong?
The problem is that the pot p2 moves curser upp/down in menus
And pot p3 Changes value!
This makes it not working to use pots! can i disconnect this funktion, or do i need to change firmware?
Searched for help on forum but with no luck!
Turnigy 9xr P2 and P3 trouble
Re: Turnigy 9xr P2 and P3 trouble
You have potscroll ON. You need to turn it OFF.
I think it is in Radio Setup/General..
João
I think it is in Radio Setup/General..
João
My er9x/Ersky9x/eepskye Video Tutorials
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
Re: Turnigy 9xr P2 and P3 trouble
Hi!
Thanks! that was right medicin but whe cant use P1,P2,P3 in mixer, value dosent change, is there anything whe have to turn on?
Whe used er9x-128.hex this would be working in this radio?
Thanks! that was right medicin but whe cant use P1,P2,P3 in mixer, value dosent change, is there anything whe have to turn on?
Whe used er9x-128.hex this would be working in this radio?
Re: Turnigy 9xr P2 and P3 trouble
Hi again!
I must have ben too tired, time to sleep it worked, loked at wrong channel haha
Thanks for the help!
I must have ben too tired, time to sleep it worked, loked at wrong channel haha
Thanks for the help!
Re: Turnigy 9xr P2 and P3 trouble
It happens all the time, specially when trying to do stuff late at night..
João
João
My er9x/Ersky9x/eepskye Video Tutorials
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW