hi sorry to buggy you but i face a issue that i dont understood,
i have 9XR and a tbs disco
and what the setting i put mode 1, mode
the rigth stick on his horizontal axis make rotate the model,
it was working before i rebind the tx, i've seeked the naza soft and found nothing related,
i verified my cable from rx to naza test both possible connection, and that not solve the issue,
have you already faced that ?
thanks a lot,
f.
mode selection seem not work
- deaconFlyer
- Posts: 76
- Joined: Fri Apr 05, 2013 11:22 am
- Country: Canada
- Location: Ontario
Re: mode selection seem not work
I may be totally off here ... but ... the hard setup of the transmitter (mode 1-4) should be matched by the selection made in the firmware otherwise you will get varying results.
Just changing the firmware setting does not change which stick is ratcheted.
You may have also changed the channel order. That will also through your settings for a loop.
It all works in a strange sort of harmony. When it is right, it is very right.
Just changing the firmware setting does not change which stick is ratcheted.
You may have also changed the channel order. That will also through your settings for a loop.
It all works in a strange sort of harmony. When it is right, it is very right.
Re: mode selection seem not work
yes as i saw in a french forum, its seem in the mixer section,
so i've put :
CH1 : AIL
CH2 : ELE
CH3 : THU
CH4 : RUD
so i've put :
CH1 : AIL
CH2 : ELE
CH3 : THU
CH4 : RUD