Hey guys, I converted over an old skysport 6 with a mega clone. I'm having a few hiccups with things. First thing is that I only have one pot hooked up, but all three inputs seem to respond to it. When I have a second pot hooked up, pot one is fine, but pot two will function pot inputs two and three. Is this normal? The other thing is that when I function the pot the battery voltage display moves. I can only adjust it in the radio setup menu with the pot, but when out of the menu it still changes the value. I don't have the u_batt input connected, could this be the reason? Anyways, here's some pictures of it pretty much finished.
Mega 2560 radio
Re: Mega 2560 radio
Everything is normal, an unconnected analog input will read the same as the last one that was sampled.
Re: Mega 2560 radio
Cool deal, thanks. Only think now that I'm fighting with is that companion can't communicate with the radio over usb after I write a firmware file to it. I have to use usbasp to modify models and have to completely rewrite the boot loader to be able to write an firmware again over usb.Kilrah wrote:Everything is normal, an unconnected analog input will read the same as the last one that was sampled.
Will
Re: Mega 2560 radio
Did you try to configure the programmer type to "arduino" in companion? I reckon it should work that way. No guarantees though as OpenTX has never been expected to be running with a 3rd party bootloader. On the 9x the flash amount was so tight that it was impossible to include a bootloader meaning an external programmer would always be needed anyway.
Re: Mega 2560 radio
I did. Didn't work.Kilrah wrote:Did you try to configure the programmer type to "arduino" in companion? I reckon it should work that way. No guarantees though as OpenTX has never been expected to be running with a 3rd party bootloader. On the 9x the flash amount was so tight that it was impossible to include a bootloader meaning an external programmer would always be needed anyway.