FlySky-FSi10 with KK2.1 , no arming

Help and support for any other brand radios
Post Reply
litse23
Posts: 72
Joined: Mon Apr 04, 2016 8:21 am
Country: Netherlands

FlySky-FSi10 with KK2.1 , no arming

Post by litse23 »

Trying to make my FlySky transmitter work together with my KK2.1 Multi-Rotor control board I have several problems.
Main problem;.
According the YouTube Videos ; I make all the proposed settings
The receiver test is OK.

Then when I run through the last Menu and I press BACK immediately power is switched off from the Control Board and the receiver automatically.
This happens every time when I go tthrough all the menus ??

Furher question what means; Channel 1: NU11 ON in the transmitter screen
further I see NO FLYMODE SELECTED, ; I see no possibillty to select any Fymode.

I hope someone has suggestions to help me further...!

Herman

komos
Posts: 20
Joined: Tue Dec 13, 2016 1:51 pm
Country: -

Re: FlySky-FSi10 with KK2.1 , no arming

Post by komos »

Go to System setup > Type select and use airplane or glider
Go back to system setup > Aux switches and enable all swithes. If you cant get more than 6 channels and you need them you may need to upgrade your tx.
Image
Go then twice back to Functions > Aux chanels and assign a switch to channel 5
Image
Now on your KK2.1 FC on at receiver test menu you should see Auxilliary channel move when you turn the SWx switch you selected on previous step.
Channel values (Aileron, Elevator, Throttle, Rudder ) should also move when you move the sticks.


I used this video https://www.youtube.com/watch?v=8NAXSBCtSLY to initially check what your FC needs. Check what happens from 2:14-2:40 and confirm same happens to you.

If nothing moves I suspect you have a wrong connection between you rx and fc

what rx you have? what have you selected in CPPM on your FC. Do you use a single wire from rx to kk2.1 or more?
Post Reply

Return to “Other Radios”