Trying to setup failsafe - zero the throttle, hold the enter long - beep.
Try it out by turning off the Tx - full power!
Any ideas pls?
X4R & XD9plus Failsafe applies full power
- randallpatrickc
- Posts: 24
- Joined: Thu Aug 04, 2016 5:09 pm
- Country: United States
- Contact:
Re: X4R & XD9plus Failsafe applies full power
Does the bar actually show the right level has been stored?
You then need to wait >15sec or so to be sure the new settings are sent to the receiver.
You then need to wait >15sec or so to be sure the new settings are sent to the receiver.
- randallpatrickc
- Posts: 24
- Joined: Thu Aug 04, 2016 5:09 pm
- Country: United States
- Contact:
Re: X4R & XD9plus Failsafe applies full power
Yes the bar is at zero - every long ENT press there is a field to the left of the scale which changes from 0.0 to HOLD to NONE
I have it on 0.0
Correct?
Waiting >15secs
I have it on 0.0
Correct?
Waiting >15secs
- randallpatrickc
- Posts: 24
- Joined: Thu Aug 04, 2016 5:09 pm
- Country: United States
- Contact:
Re: X4R & XD9plus Failsafe applies full power
Update - I tried NONE on the throttle and hey-presto - it drops to zero on Tx off
Bolstered by success, I did the same with ELE, held up ELE, turned off Tx and up ELE remained!
There's something I don't understand here!
Bolstered by success, I did the same with ELE, held up ELE, turned off Tx and up ELE remained!
There's something I don't understand here!
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: X4R & XD9plus Failsafe applies full power
Throttle off is -100%, not zero (0.0%).
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
- randallpatrickc
- Posts: 24
- Joined: Thu Aug 04, 2016 5:09 pm
- Country: United States
- Contact:
Re: X4R & XD9plus Failsafe applies full power
Yes - all the way off - the bar is all the way to the left in my case
Re: X4R & XD9plus Failsafe applies full power
There are TWO bars, one shows the current poaition and the other one the stored failsafe position.
If you see 0.0 then you have mid throttle set, you must see -100.
Long press changes mode. Once you're in "value" mode you press enter SHORT to edit it. Either you set with the +/- keys, or NOW in edit mode long press enter to save the current position.
If you see 0.0 then you have mid throttle set, you must see -100.
Long press changes mode. Once you're in "value" mode you press enter SHORT to edit it. Either you set with the +/- keys, or NOW in edit mode long press enter to save the current position.
Re: X4R & XD9plus Failsafe applies full power
I have the same problen. I want failsafe on my glider to be power off and slight right rudder, but when I turn off the TX I get power on and FULL FLAPS and, yes, I have selected the rudder channel and not the flaps channel. I don`t understand it