Taranis q x7 Flash issue

Hardware help and support for the FrSky Taranis
Post Reply
Ghost40
Posts: 1
Joined: Mon May 28, 2018 9:02 pm
Country: -

Taranis q x7 Flash issue

Post by Ghost40 »

Hello all

I Just want to get it out of the way that I am new to the rev world but certainly not new to modded firmware.

Picked up a new Taranis q x7 and was following a tutorial on Youtube (not sure if the name) that resulted in a brick

I have installed Zadic with now issues. Tried flashing opentx 2.2.0 and I had no warnings or errors. When starting up the Taranis I get a 4 dotted screen then release the power button. All the while it says welcome to opentx. Then the device says “throttle warning” (I think), then a red power button and no display.

The firmware was downloaded from opentx and I used the companion. Mostly default settings. I have tried both with and with out an sd card, and several different ones.

I tried to flash the back and it results in the same behavior just no voices and a very loud beep. I downloaded the firmware from Frsky and attempted that way as well.

I have tried different USB ports and cables. And to note, it booted up fine before the flashing.

Help?

Post Reply

Return to “FrSky Taranis radio”