problem to bind XM to Taranis X9D plus

Hardware help and support for the FrSky Taranis
Post Reply
Viceroy86
Posts: 1
Joined: Fri Jul 21, 2017 8:16 am
Country: -

problem to bind XM to Taranis X9D plus

Post by Viceroy86 » Fri Jul 21, 2017 8:21 am

I got this tiny whoop 6 with XM receiver, i firmwared XM with newest frsky firmware and tried to bind it with D16 mode and it look it workd but i only got the green light but cant do nothing with taranis, tried to set up betaflight Channel Map is right TAER1234 and its the same in my taranis mode 2. Just nothing happens in Reveiver tab in betaflight. What did I do wrong?

Mirrikat
Posts: 1
Joined: Tue Aug 08, 2017 8:39 pm
Country: -

Re: problem to bind XM to Taranis X9D plus

Post by Mirrikat » Tue Aug 08, 2017 8:46 pm

I'm having the exact same issue. Taranis and bootloader are non-eu firmware 2.1.9 and the internal rf has been flashed with the latest .frk file from the FrSky website. I was able to get the FrSky XM SBUS receiver to bind to the Taranis. (I get a green light on the receiver whenever I turn on the Taranis so I'm pretty confident that it is bound correctly).

In BetaFlight I've set the Ports and Configuration to Serial-based receiver SBUS and I've clicked "Save and Reboot"

In the receiver tab I can see the colored bands but with the radio on, when I move the throttle, roll, pitch, yaw nothing happens on the screen.

Even though my radio is bound to the receiver, it is either not talking to the receiver or the receiver is not talking to the fc.

Also every time I disconnect and reconnect to Betaflight the SBUS setting reverts to SPEKTRUM 1024

Post Reply

Return to “FrSky Taranis radio”

Who is online

Users browsing this forum: No registered users and 6 guests