Hi,
I'm trying to configure and calibrate my S6R using the STK USB I just bought.
All seems to be working well until I do the WRITE after the calibration in the config program.
I receive this message from the config program S6R V1.1:
S6R config has stopped working, program will closes and reopens with COM1 (default).
I checked my STK USB driver and they are COM4.
I followed all the steps in instructions of S6R.
Did anyone get this message after the WRITE click after calibration?
The S6R works fine when I put servos on it but the accelerometers don't seem to be calibrated.
My Taranis is ON during all the steps and CH9,10,11 are not set during calibration, not defined in mixer menu.
Am I missing something?
Please advise,
Thanks,
Ray
S6R PC configuration with STK
-
- Posts: 284
- Joined: Sat Apr 16, 2016 11:33 pm
- Country: -
-
- Posts: 284
- Joined: Sat Apr 16, 2016 11:33 pm
- Country: -
Re: S6R PC configuration with STK
Hi
OK I found the problem.
I downloaded the config program V1.1 and there is a V1.3.
It works now with V1.3.
Not sure how I obtained the old V1.1
OK I found the problem.
I downloaded the config program V1.1 and there is a V1.3.
It works now with V1.3.
Not sure how I obtained the old V1.1