Page 1 of 1

Trim and endpoints

Posted: Sun Jan 01, 2017 12:50 am
by Ahamm001
Hello there. I'm new to Taranis and I'm told I will love it if I can figure out the programming. Well, I ended up using ppm center to center.control.surfaces my control surfaces because I didn't like subtrim giving me unequal movement on side to the other........was this a good idea? Also I have never flown with expo at all, I always just backed off the throws.........is it possible to do this with endpoints even though I used ppm center to center the throw surfaces? Any help is appreciated......thanks.....

Re: Trim and endpoints

Posted: Sun Jan 01, 2017 8:38 am
by Kilrah
Yes PPM center is perfect for initial servo horn centering.

To get good habits setting your throws should be done in Inputs.