Trim and endpoints

General Help and support for the Taranis Radio.
Post Reply
Ahamm001
Posts: 2
Joined: Sat Nov 26, 2016 3:28 am
Country: -

Trim and endpoints

Post by Ahamm001 » Sun Jan 01, 2017 12:50 am

Hello there. I'm new to Taranis and I'm told I will love it if I can figure out the programming. Well, I ended up using ppm center to center.control.surfaces my control surfaces because I didn't like subtrim giving me unequal movement on side to the other........was this a good idea? Also I have never flown with expo at all, I always just backed off the throws.........is it possible to do this with endpoints even though I used ppm center to center the throw surfaces? Any help is appreciated......thanks.....

User avatar
Kilrah
Posts: 8915
Joined: Sat Feb 18, 2012 6:56 pm
Country: United Arab Emirates

Re: Trim and endpoints

Post by Kilrah » Sun Jan 01, 2017 8:38 am

Yes PPM center is perfect for initial servo horn centering.

To get good habits setting your throws should be done in Inputs.

Post Reply

Return to “General help (FrSky Taranis radio)”

Who is online

Users browsing this forum: No registered users and 3 guests