Channel monitor not responding after update to 2.0.01

General Help and support for the Taranis Radio.
Post Reply
lekial
Posts: 1
Joined: Fri Jun 06, 2014 2:04 pm
Country: -

Channel monitor not responding after update to 2.0.01

Post by lekial »

Hi, I am a new user of Taranis and it came pre-loaded with Firmware v1.1.02. I updated it to v2.0.00 and shortly after, v2.0.01 and realised that my channel monitor is not responding to any stick movements. I remembered it was working when I just got it with the v1.1.02 firmware. Any ideas what went wrong here?

User avatar
dinamich
Posts: 288
Joined: Mon Apr 01, 2013 1:21 pm
Country: Slovenia
Location: Ljubljana

Re: Channel monitor not responding after update to 2.0.01

Post by dinamich »

Are you saying that servos move, but the channel monitor values are not moving? I find that hard to believe. Try creating a new model.
projectkk2glider@github
User avatar
gohsthb
Posts: 1412
Joined: Wed Dec 28, 2011 2:32 pm
Country: -
Location: Naperville, IL

Re: Channel monitor not responding after update to 2.0.01

Post by gohsthb »

Sounds like you are off a screen, I have a 9x so I would use the left and right buttons to switch between sets of channels that are displayed. There must be something similar on taranis. This must be what had happened to you, you are just looking art a different set of channels.
-Gohst

Sent from my LG-D801 using Tapatalk

Post Reply

Return to “General help (FrSky Taranis radio)”