Channel monitor not responding after update to 2.0.01
Channel monitor not responding after update to 2.0.01
Hi, I am a new user of Taranis and it came pre-loaded with Firmware v1.1.02. I updated it to v2.0.00 and shortly after, v2.0.01 and realised that my channel monitor is not responding to any stick movements. I remembered it was working when I just got it with the v1.1.02 firmware. Any ideas what went wrong here?
Re: Channel monitor not responding after update to 2.0.01
Are you saying that servos move, but the channel monitor values are not moving? I find that hard to believe. Try creating a new model.
projectkk2glider@github
Re: Channel monitor not responding after update to 2.0.01
Sounds like you are off a screen, I have a 9x so I would use the left and right buttons to switch between sets of channels that are displayed. There must be something similar on taranis. This must be what had happened to you, you are just looking art a different set of channels.
-Gohst
Sent from my LG-D801 using Tapatalk
-Gohst
Sent from my LG-D801 using Tapatalk