Hello guys,
since a long while, I´ve often problems with my Taranis, that sporadically looses correct telemetry reading and logging.
I´m still unsure what could cause this. My setup is X8R, SmartPort Vario (used as bridge), FLVS and FAS40.
Do you have any suggestions?
Regards
Koffi
Taranis looses telemetry connection
Taranis looses telemetry connection
- Attachments
-
-
Rob Thomson
- Site Admin
- Posts: 4543
- Joined: Tue Dec 27, 2011 11:34 am
- Country: United Kingdom
- Location: Albury, Guildford
- Contact:
Re: Taranis looses telemetry connection
Are you on the latest opentx version?
I believe a CRC bug was fixed to solve this.
Sent from my GT-I9300 using Tapatalk
I believe a CRC bug was fixed to solve this.
Sent from my GT-I9300 using Tapatalk
Slope Soaring, FPV, and pretty much anything 'high tech'
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
...........if you think it should be in the wiki.. ask me for wiki access, then go add it!
Re: Taranis looses telemetry connection
No, that only affected a single value once in a while.
The smartport vario however would freeze randomly that way, there's a firmware upgrade for it on FrSky's site.
The smartport vario however would freeze randomly that way, there's a firmware upgrade for it on FrSky's site.
Re: Taranis looses telemetry connection
Hello,
thanks for your ideas, but the vario is already updated.
I´ve ordered new hardware (SmartPort current sensor and Lipo sensor) and will check then again. Perhaps something on the sensors PCB has fault connections...
Regards
Koffi
thanks for your ideas, but the vario is already updated.
I´ve ordered new hardware (SmartPort current sensor and Lipo sensor) and will check then again. Perhaps something on the sensors PCB has fault connections...
Regards
Koffi