fas-100 problem on telemetry

[chrlie]

i´ve connected fas-100 to x8r receiver, set everthing on taranis telemetry.
i have always 80 Amp and more on telemetry, engine is off, only bec for receiver on batterie.
Is there a software problem or is this a settigng or sensor problem.

Ive changed differend types of receiver, always same problem??

[Kilrah]

What did you do exactly? The FAS-100 can't be connected directly to an X8R, as it's not a smart port equipped sensor.
You would need the new vario sensor as a bridge.

Sent via mobile

[chrlie]

Yes, vario was as a Bridge between Sensor and Receiver, but i have tried it directly with the d8r-II plus and its the Same Problem

[Kilrah]

Please post your EEPROM or at least list all the telemetry settings you use on the radio. FAS should just work when selecting FAS as current source and displaying Curr.

Sent via mobile

[chrlie]

thank you for help, my eeprom, model surprise16

[chrlie]

in this eeprom i used first x8r receiver and d8r-IIplus now

[Kilrah]

Looks OK, I'd suspect a defective sensor.

What do you get when you display Vfas? You should have your battery voltage.

[Koffi]

I had a similar Problem with FAS. It was the Sensors that was defective, no idea why...

[chrlie]

Is there any Chance to fix ist Ort do i have to büx a New One

Vortage on Display is ok

[chrlie]

Sorry iPad!!!!!!
Is there any chance to fix it or do i have to buy a new one?

Voltage on display is ok

[Kilrah]

Probably need to return it for exchange.

[chrlie]

Thanks to all of you, i reported the problem to hk

[Sideslip]

Did you buy this FAS-100 from hobbyking? It is possible you got one of the FAS-40 sensors reworked for 100 amps which is labled as a FAS-100. See the thread about it here:

http://openrcforums.com/forum/viewtopic ... sor#p43107

Joe