openrcforums

Hi all I decided to build a drone and upon completion I decided to copy my old model and simply bind the new receiver . Everything seems ok. So I have 2 models and 2 drones ...but yesterday I noticed I can control either of my 2 drones with either of the 2 models.... even though they are 2 different receivers.. is normal or even a feature when copying a model to use with another drone? Many thanks

Sent from my SM-G920F using Tapatalk

Firstly availability of that functionality depends on the receiver type you're using.

If supported with your combination you need to change the "Receiver no" in the RF settings so each model uses a different one.

Kilrah wrote:Firstly availability of that functionality depends on the receiver type you're using.

If supported with your combination you need to change the "Receiver no" in the RF settings so each model uses a different one.

Thanks all fixed

Sent from my SM-G920F using Tapatalk

Kilrah wrote:Firstly availability of that functionality depends on the receiver type you're using.

If supported with your combination you need to change the "Receiver no" in the RF settings so each model uses a different one.

I changed the number but now it doesent work. Only when I change it back so there both number 1 they work again as in my first post

Sent from my SM-G920F using Tapatalk

Bind the receiver again with the new receiver number selected..

João

You obviously need to rebind after changing number.

I'm a complete newb and still learning. Thanks for helping

Sent from my SM-G920F using Tapatalk