Internal XJT flashed with XJT_LBT_build151223.frk
XSR flashed with XSR_LBT-build151118.frk
When I power the xsr in bind mode all i get is solid red and green leds, no bind.
I've opened up taranis to check ribbon cables, all good, tried different bec rx power and all sorts of xjt/xsr fw combos with the same results.
Please help, Appreciated.
I can't bind my xsr to taranis plus
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: I can't bind my xsr to taranis plus
Try using a different receiver number in the protocol setup.
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: I can't bind my xsr to taranis plus
I've tried that, unfortunately it didn't work either
I've have a new RF modul with non-eu fw on the way, hoping to resolve the issues I'm experiencing with my current 'EU' marked one.
Cross fingers
I've have a new RF modul with non-eu fw on the way, hoping to resolve the issues I'm experiencing with my current 'EU' marked one.
Cross fingers
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: I can't bind my xsr to taranis plus
How many different receiver numbers have you tried? If not already tried, test with 1 through to 10.
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!