Page 1 of 1

T9x + AR9x board + OpenTx: Rotary Encoder issue

Posted: Thu Feb 16, 2017 9:20 am
by vian31
Hello all,

I am not able to do my rotary encoder working on the T9x with the AR9X board (except the PB). OpenTx is ver. 2.1.9 but does not show the "RotEnc Navig" option in the Tx parameters' page DESPITE I can see it either in Companion and in the Simulator.

I have checked the compilation's options of the firmware but no one relative to.

Someone could help please ?
Many thanks.
Vianney

Re: T9x + AR9x board + OpenTx: Rotary Encoder issue

Posted: Thu Feb 16, 2017 9:45 am
by jhsa
I think in companion, before you generate the firmware for your radio, there are some options you need to select so they are included. I believe the encoder is one of them. At least it was like that when I tried openTX a few years ago as far as I remember..

João

Re: T9x + AR9x board + OpenTx: Rotary Encoder issue

Posted: Thu Feb 16, 2017 10:02 am
by vian31
As I said in my last sentance, I have checked all these options of compilation but none of them looks relative to the Rotary Encoder.
Would be the "potscroll" option ? I have to try. But not confident because even if not chosen in Companion firmware' options the RotEnc option appears in the simulator.

Re: T9x + AR9x board + OpenTx: Rotary Encoder issue

Posted: Thu Feb 16, 2017 10:59 am
by jhsa
Then I don't know, hopefully someone from the OpenTX team can help you with that.
I use Ersky9x on my radios and I find the setting in the hardware menu. I mean encoder is always enabled, we just have to set the divider so it works smoothly..

João

Re: T9x + AR9x board + OpenTx: Rotary Encoder issue

Posted: Thu Feb 16, 2017 11:21 am
by Kilrah
The checkbox seems to be missing indeed, issue opened.
https://github.com/opentx/opentx/issues/4468

Re: T9x + AR9x board + OpenTx: Rotary Encoder issue

Posted: Thu Feb 16, 2017 2:23 pm
by vian31
Thanks Kilrah for your prompt answer. I would have helped if I had any C++ programming skill.
Good job.
Vianney