Recently I flashed the Betaflight firmware to my Flip 32(REV5, 6 DOD) board.
The flashing procedure was succesful.
I tried to connect the board, there was connection.
Now in the SETUP I want to callibrate the accellerometer., the colour of the yellow block turns into white for a very short time. Then again into yellow. Every time again when I try).
So think no calibration has taken place.
Also the calibrate magnetometer block is gray and so not available.
I had the same problem with other Naze32 boards and with CleanFlight firmware !!
I simply do not come through the process of callibrating the accellerometer and the magnetometer. It looks to me not a problem with the firmware
I wonder kow can I solve the problem.
Naze 32 callibration problem
Re: Naze 32 callibration problem
You already asked that here: viewtopic.php?f=94&t=9701
As mentioned this forum is not the best place to ask as we are not experts on those boards.
Closing duplicate
As mentioned this forum is not the best place to ask as we are not experts on those boards.
Closing duplicate