PXR Pro Elevator action showing reversed on screen!?!?!

[akura2]

I just got my 9XR Pro and when I turn it on, and move the elevator stick, the image on the screen moves in the opposite direction (ie when I move the stick forward, the 'little dot' goes down and vice versa)

this may be a newbie fix, or a reversed pot, but if anyone can help me before I take any of my flying vehicles up, I'd appreciate it


Thanks

[jhsa]

Ok, I'm not sure what version of ersky9x your radio has installed..
Do you have an "Hardware" menu in radio setup?
If so, enter it, scroll down or up to "Stick Reverse", and make sure none of the sticks is highlighted.
To enter the hardware menu you might have to enable it as it is protected. To do so, please turn your radio ON while holding the left horizontal trim to the left for about a second, then release it. Now you can enter the hardware menu..

João

[MikeB]

Please go to the "DIAGANA" screen (hold the LEFT side of the cross switch down, then go to the DIAGANA screen).
Assuming you are using "Mode 2" (elevator stick on the right), look at the number beside A3. This should start with 03 or 04.
When you move the stick forward (down elevator) this number should increase.

Mike.