Problem with NAZA-M Lite Flight Controller (fixed)

[bob195558]

Hi,
When I added the NASA FPV OSD N1 module (FPV Flight Controller FF0SD N1OSD Module for DJI NAZA V1 V2 NAZA Lite GPS)
(http://www.ebay.com/itm/301693183265) to my NAZA-M Lite Flight Controller, the Red LED is flashing very fast all the time now.
I removed the NASA FPV OSD N1 module and it is still flashing very fast all the time.

The FPV Flight Controller FF0SD N1 OSD Module was displaying properly, but I have not tried to make any setting changes to it.
Could the NASA FPV OSD N1 module have altered the NAZA-M Lite Flight Controller Setting ?

Anyone know what this problem may be ?

Bob B.

[bob195558]

I found the problem !
It was that I needed to change (correct) the F/C PID Gain settings (YAW) to match the Mixes (radio program settings) in my erSky9x on Taranis.
So when connecting the NAZA-M Lite Flight Controller to the PC I got this error message:

And so the Yaw was at 300% instead of 150% and set to X1 for Taranis radio S1-Pot to be able adjust the YAW settings when flying.
I had changed, in radio Mixes channel 8 to PPM8 for the FPV pan & tilt settings so I could not use S1-Pot YAW adjustment.
When I made the correct settings, the RED LED light's constant fast flashing went away.

The proper radio settings to match NAZA-M Lite F/C settings.

I am using "erSky9x on Taranis" with my Taranis-X9D radio.

Bob B.

Other info here: (http://openrcforums.com/forum/viewtopic ... te#p116428)
and (http://openrcforums.com/forum/viewtopic ... 23&t=11214).