Hi folks:
I just reflashed my second 9x, but after recalibrating the sticks and pots, only half of the full pot revolution is shown in the bar graph on the main screen.
I turned the pots to their other extreme and recalibrated...then only the bottom half of the bar graph corresponded to the full pot movement.
I didn't have any problems on the first 9x and everything else is ok on this second one.
Any thoughts?
ver-r708
Thanks
John
Three Potentiometer Bargraphs only display 1/2
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Three Potentiometer Bargraphs only display 1/2
Did you set them to the middle when centering the sticks?
I go to the ANA setup screen (5/7) and set the pots so the values by A5, A6 and A7 are 0400, to get them in the centre, then do the calibration.
Mike.
I go to the ANA setup screen (5/7) and set the pots so the values by A5, A6 and A7 are 0400, to get them in the centre, then do the calibration.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: Three Potentiometer Bargraphs only display 1/2
Aha! Thanks Mike. I will give that a try. I guess on my first 9x the pots must have been in the middle, by chance;)
Thanks so much
John
Thanks so much
John
Re: Three Potentiometer Bargraphs only display 1/2
Yes! That did it! So make sure your pots are also centered before calibrating.
Thanks
John
Thanks
John