Hello all,
I recently acquired a DX5E radio. I removed the RF module, I would like to install this module into my Futaba 8FG. The only problem that I'm seeing so far is how to wire up the X1TX0 for binding. I already have a momentary switch, i just need to know which of the 12 header pin do I use for binding.
Thanks
DX5E X1TX0 with Futaba 8FG
Re: DX5E X1TX0 with Futaba 8FG
I doubt anyone here even use a Futaba radio.
We normally use and discuss radios that support open source firmware, and futaba is not one of them.
To be honest, I don't even think that what you are trying to do is possible as I can't see the Futaba software supporting the DX5 protocol.
Are you following some tutorial to do that mod?
João
Sent from my BLN-L21 using Tapatalk
We normally use and discuss radios that support open source firmware, and futaba is not one of them.
To be honest, I don't even think that what you are trying to do is possible as I can't see the Futaba software supporting the DX5 protocol.
Are you following some tutorial to do that mod?
João
Sent from my BLN-L21 using Tapatalk
My er9x/Ersky9x/eepskye Video Tutorials
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW