Hi, I have a Q X7 and have the latest open tx firmware on it. It is set up mode 2, with channel assignment AETR. However the throttle is operated by the elevator stick. No matter of which combination of mode or channel assignment that I use will give the correct output at the receiver. The receiver used is the S6R which is stabilised so all channels need to be correct.
In addition I have the irange multi mode module for my indoor flying quads, I cannot get the correct channel assignment with these models either.
Is it possible anyone could advise on this?
I now seem to have tried all options and have mentally consigned it all to the bin.
TIA Adrian
Q X7 channel assignment wrong
Re: Q X7 channel assignment wrong
I believe that changing the channel order only affects new models. On existing models, you must change the source assignment in the mixer..
If you create a new model, it will be created with the new channel order you've set..
João
If you create a new model, it will be created with the new channel order you've set..
João
My er9x/Ersky9x/eepskye Video Tutorials
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
-
- Posts: 3
- Joined: Sat Sep 09, 2017 10:03 pm
- Country: -
Re: Q X7 channel assignment wrong
Hi Joao, thanks for your reply. It's the same if I set up a new model also. I have tried different channel orders when flashing the radio and it's still the same problem.
Can you alter the source assignment in the mixer from the radio itself. Kind regards Adrian
Can you alter the source assignment in the mixer from the radio itself. Kind regards Adrian
-
- Posts: 3
- Joined: Sat Sep 09, 2017 10:03 pm
- Country: -
Re: Q X7 channel assignment wrong
hi again Joao,
I've managed to do it, thank you very much. Didn't realise needed long press to open up the mixer edit function, foolish me.
Thanks once again for your help, it greatly appreciated. Kind regards Adrian
I've managed to do it, thank you very much. Didn't realise needed long press to open up the mixer edit function, foolish me.
Thanks once again for your help, it greatly appreciated. Kind regards Adrian
Re: Q X7 channel assignment wrong
João
My er9x/Ersky9x/eepskye Video Tutorials
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW