Hi,
I'd like to use the trim buttons of my Q X7 as a switch. The way I intend this to work out is like this: Throttle Trim up is pressed -> Throttle doesn't get trimmed, but a Channel goes from low to high -> Channel stays high until Throttle Trim up gets pressed again -> Channel goes to low again.
I'm aware that using a switch would be way easier, but that isn't the point. Thanks for any answers and happy flying,
lustig1374
Using the trim buttons as a switch
-
- Posts: 2
- Joined: Wed Jul 13, 2016 9:46 pm
- Country: -
Re: Using the trim buttons as a switch
An LS with "Stky tTu tTu".
And disable the throttle trim in the flight modes, although I see that this is currently missing from the X7 screen for the default flight mode, so has to be done from companion until next build.
I assume you do not need throttle trim at all.
And disable the throttle trim in the flight modes, although I see that this is currently missing from the X7 screen for the default flight mode, so has to be done from companion until next build.
I assume you do not need throttle trim at all.