Recently I flashed the Betaflight firmware to my Flip 32(REV5, 6 DOD) board.
The flashing procedure was succesful.
I connect the board, there is connection.
Now in the SETUP I want to calibrate the accellerometer., the colour of the yellow block turns into white for a very short time. Then again into yellow. Every time again when I try).
So think no calibration has taken place.
Also the calibrate magnetometer block is gray and so not available.
I wonder kow can I solve the problem.
(exact the same problem I have with another NAZE32 board)
cannot calibrate accellerometer
Re: cannot calibrate accellerometer
Wrong forum, I would suggest -> https://www.rcgroups.com/forums/showthr ... ion-Thread