Help with eepe file please
Posted: Sun Dec 04, 2016 4:38 pm
Hello All,
I thought I was getting fairly proficient at basic model set up but...
Attached is an eepe for my Fun Cub. In addition to 2 Ail, 1 Elev, Thr, 1 Rud and 2 Flap Servos on a Y cord) servo operation with high and low rates, I added a mix for some slight down elevator with increasing throttle, and a mix for slight down Elev with half flap and a bit more with full flap.
Issues are that when checking function on the servo screen Elev does not work at all when switched to low rates but Ail and Rud do and the programming looks the same to me.
And, the down Elev mix with Thr and Flaps on the servo screen does not work either.
It would be appreciated if someone could point out my errors.
Thank you, Doc
I thought I was getting fairly proficient at basic model set up but...
Attached is an eepe for my Fun Cub. In addition to 2 Ail, 1 Elev, Thr, 1 Rud and 2 Flap Servos on a Y cord) servo operation with high and low rates, I added a mix for some slight down elevator with increasing throttle, and a mix for slight down Elev with half flap and a bit more with full flap.
Issues are that when checking function on the servo screen Elev does not work at all when switched to low rates but Ail and Rud do and the programming looks the same to me.
And, the down Elev mix with Thr and Flaps on the servo screen does not work either.
It would be appreciated if someone could point out my errors.
Thank you, Doc