Taranis Plus 2.1 firmware upgrade fail - any thoughts?
Posted: Fri Nov 25, 2016 5:39 am
Hello All,
Was able to update from 2.0.17 to 2.0.20.
I read thru instructions on RC Groups and OpenTXU for Taranis Plus 2.1 firmware upgrade.
Followed Painless 360's video step by step.
Have a windows 7 laptop.
Open Companion for 2.1, Tx off, plug in USB, click on "write firmware to radio.
I get a fast filling green progress bar - says "flashing done (exit code = 1)
Then a window pops up and says "firmware check failed - could not check firmware from radio".
Any solutions?
Thanks for helping,
Doc
Was able to update from 2.0.17 to 2.0.20.
I read thru instructions on RC Groups and OpenTXU for Taranis Plus 2.1 firmware upgrade.
Followed Painless 360's video step by step.
Have a windows 7 laptop.
Open Companion for 2.1, Tx off, plug in USB, click on "write firmware to radio.
I get a fast filling green progress bar - says "flashing done (exit code = 1)
Then a window pops up and says "firmware check failed - could not check firmware from radio".
Any solutions?
Thanks for helping,
Doc