Hello everyone, I'm new here.
I have not yet received my 9x, but I've been looking at getting a cheap USBasp from ebay as well as a connector to mount on the tx. I've seen some people use different connectors here, including ps/2 and d-sub. I was originally just going to use a male connector like that on the USBasp, but finding a 10 pin IDC header for ribbon cables (with strain relief piece?) seems to be impossible. Where can I find one?
What plug to use?
Re: What plug to use?
http://www.sparkfun.com/products/10877
http://www.sparkfun.com/products/8506
But the connector is not easy to use. Using a connector designed to be plugged and unplugged is much easier.
Also, consider leaving the programmer in the radio and plugging in with a USB plug.
http://www.sparkfun.com/products/8506
But the connector is not easy to use. Using a connector designed to be plugged and unplugged is much easier.
Also, consider leaving the programmer in the radio and plugging in with a USB plug.
Z
BEWARE - WE ARE IN THE AIR!!!
What goes up... Should be controlled by a 9X!
BEWARE - WE ARE IN THE AIR!!!
What goes up... Should be controlled by a 9X!
Re: What plug to use?
Thanks, but those don't seem to be for use with ribbon cables. Is there a specific connector you recommend?
Re: What plug to use?
I found this the easiest to wire up:
http://er9x.googlecode.com/svn/trunk/do ... hookup.pdf
You can also see my original guide here:
http://er9x.googlecode.com/svn/trunk/do ... e%209x.pdf
BTW, the programmer HobbyKing sells is cheap and works great:
http://www.hobbyking.com/hobbyking/stor ... duct=21321
Hope this helps.
Jon
http://er9x.googlecode.com/svn/trunk/do ... hookup.pdf
You can also see my original guide here:
http://er9x.googlecode.com/svn/trunk/do ... e%209x.pdf
BTW, the programmer HobbyKing sells is cheap and works great:
http://www.hobbyking.com/hobbyking/stor ... duct=21321
Hope this helps.
Jon