Custom Switches

[csquared]

I have a Taranis x9d running r2940 and companion9x in Windows 7.

I am trying to create a custom switch to monitor the transmitter battery so that I can have a special announcement reported if the battery drops below a special value. ( I realize that the transmitter also checks this voltage. ) In Custom Switches I tried to add a cs1 a<x Batt . When I try to set the voltage value companion9x only allows me to enter integer values.

I was able to enter the value I wanted just using the radio but when I donwloaded the setup into companion9x the value was zeroed out?

Any ideas??