OpenTx Companion seems to corrupt the telemetry configuration for FRSky redundancy bus

Help with any software/desktop related issues. e.g. companion9x, eePe, etc
Post Reply
NickOoo
Posts: 1
Joined: Fri May 12, 2017 12:51 pm
Country: -

OpenTx Companion seems to corrupt the telemetry configuration for FRSky redundancy bus

Post by NickOoo » Fri May 12, 2017 1:10 pm

Have Taranis+ running R2.1.9 firmware...(and using Companion 2.1.9)

When I set the Taranis+ to discover sensors it correctly picks up all Redundancy Bus telemetered values including RB1V, RB1A, RB1C, RB2V, RB2A, RB2C.

BUT

if I copy the model configuration to OpenTX Companion and then back into the radio (without changing anything) the telemetered value for RB1A then reads the same value of the value shown for RB1V. Also the telemetered value for RB2A reads the same value of the value shown for RB2V.

To fix this I have to have manually delete RB1V, RB1A, RB2V and RB2A in the Tarsnis+ and add them back in. Then the telemetered values look ok again.

Of course every time I want to modify the model configuration in Companion and upload to the Taranis+ it breaks RB1A and RB2A values again!!!

Any thoughts on what the problem is??

thanks for any suggestions
NickOO

Post Reply

Return to “Software”

Who is online

Users browsing this forum: No registered users and 3 guests