Newbie needs help connecting with Open TX
Posted: Tue Dec 06, 2016 11:16 pm
Hello,
New to Taranis but have stalled connecting to Open TX. Managed to set up the model via the radio buttons but see this being a bit tedious in the future.
I have a Dell Laptop with Windows 10. I believe it has USB 3.0
I have a newly bought FrSky Taranis Plus X9D plus. its running 2.1.6 firmware. Eu LBT.
I have installed Open TX 2.1.6 also.
I have installed Zadig 2.2
I can see the STM32 bootloader when I connect the radio turned off in device manager.
When I try to enter bootloader mode on the radio and connect the USB cable radio tells me USB connected but Open TX says, "not responding"
"Radio not found"
"Your radio does not seem to be connected or USB driver installed, please use Zadig"
Please can someone help as I have read and watched many tutorials online and am out of ideas...
Thanks
New to Taranis but have stalled connecting to Open TX. Managed to set up the model via the radio buttons but see this being a bit tedious in the future.
I have a Dell Laptop with Windows 10. I believe it has USB 3.0
I have a newly bought FrSky Taranis Plus X9D plus. its running 2.1.6 firmware. Eu LBT.
I have installed Open TX 2.1.6 also.
I have installed Zadig 2.2
I can see the STM32 bootloader when I connect the radio turned off in device manager.
When I try to enter bootloader mode on the radio and connect the USB cable radio tells me USB connected but Open TX says, "not responding"
"Radio not found"
"Your radio does not seem to be connected or USB driver installed, please use Zadig"
Please can someone help as I have read and watched many tutorials online and am out of ideas...
Thanks