Does anyone know if ppm and sport module pins are connected to a uart on the horus? Is there a schematic available?
thanks,
Brendin
Horus module pin hardware connections
Re: Horus module pin hardware connections
Sport yes, PPM no.
Re: Horus module pin hardware connections
Thanks. Sport on rx or tx of uart?Kilrah wrote:Sport yes, PPM no.
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Horus module pin hardware connections
SPort is half duplex, so both Tx and Rx.
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: Horus module pin hardware connections
What processor is used by the horus and which pin number is the sport connected to? Are there any hardware details available anywhere? I am assuming there must be as the opentx team would have a hard time developing without them. I'd like to write some code for opentx to be able to take serial telemetry data from the hitec module. This would allow me to connect the module without needed to use an arduino to emulate sport. I was hoping I could feed the serial into the SPORT pin. I'd make a new module type for the hitec module.
Re: Horus module pin hardware connections
The easiest is to look at the OpenTX code, everything is referenced there.
Envoyé de mon SM-G930F en utilisant Tapatalk
Envoyé de mon SM-G930F en utilisant Tapatalk