Timer for Multicopter?

[Helitamer]

Hi,

is it possible configure one timer in this way if i move both sticks to bottom and middle start the timer same time motor starts?

Regards Helitamer

[Helitamer]

Hi,

this work:

CS1 a~x thr -100
CS2 a~x rud +100 CS1
CS3 a~x Ele -100 CS2
CS4 a~x ail -100 CS3

Timer1 CS4t

[FlyingDutchman]

Does anyone knows how the last line will look like in the 2.0 version of OpenTX. All the other CS* were replaced by the L but in the last line there is no Lt to keep the timer running, so it stops everytime I losen the gimball sticks. Thank you.

Willem, Amsterdam

[Kilrah]

L5 Sticky L4 L4
Timer1 L5

[FlyingDutchman]

Thank you very much. That was the trick. Is there perhaps some kind of document for newbees like me which explains these lines in beginners language ? Anyhow, thanks a lot for your help. Even when I don't understand it, it works.

[kbayquoi]

Dupe

[kbayquoi]

Hi,

this work:

CS1 a~x thr -100
CS2 a~x rud +100 CS1
CS3 a~x Ele -100 CS2
CS4 a~x ail -100 CS3

Timer1 CS4t

Just found this, and it works great for my phantom 2. But now I have another question...(Sorry, but I am a noob)

How could I set the SH switch to stop and reset this timer to 0 and have it start again the next time the switches start the above sequence?

Thanks so much,
Ken