The communication between TX and PC looks ok. I backed up the SD, as well as the EEPROM and radio models and settings in Companion 2.0. However, when I try to upload the 2.1 FW from Companion 2.1, I get the attached screen.
I can see the STM Device in DFU mode in the USB controllers list. I am running Windows 10.
Please, help me.
Cannot upgrade the 9XD from 2.0 to 2.1
Re: Cannot upgrade the 9XD from 2.0 to 2.1
"STM Device in DFU mode" is precisely not the correct driver.
Upgrade in bootloader mode instead of messing with that.
Upgrade in bootloader mode instead of messing with that.
-
- Posts: 183
- Joined: Sat Mar 29, 2014 10:44 pm
- Country: United States
- Location: Coral Springs, FL
Re: Cannot upgrade the 9XD from 2.0 to 2.1
Fine, Kilrah, and how do I do that? Can you give me a link where I can follow a procedure? I watched the video https://www.youtube.com/watch?v=fqfRfnwPbJE which follows the steps of the link https://www.rcgroups.com/forums/showthr ... enTX-2-1-X.
It is obvious that I am missing something. I am lost here. Please, give me a lead to follow.
Thank you
It is obvious that I am missing something. I am lost here. Please, give me a lead to follow.
Thank you
Richard
-
- Posts: 183
- Joined: Sat Mar 29, 2014 10:44 pm
- Country: United States
- Location: Coral Springs, FL
Re: Cannot upgrade the 9XD from 2.0 to 2.1
Thank you. The video https://www.youtube.com/watch?v=DsbaftCHpHs shows the right way to do that.
Richard