Trims don't actually change servos - Horus/Opentx 2.2

Post Reply
elib100
Posts: 11
Joined: Sun Aug 07, 2016 10:27 pm
Country: -

Trims don't actually change servos - Horus/Opentx 2.2

Post by elib100 »

When I try to trim an aircraft on my new Horus running Opentx 2.2 it doesn't change anything. I hear the beeps and the display shows the trims changing but the actual servos aren't changing. I went and checked and the trim box is checked in both the input and the mix. Is there anywhere else I should check it? I'm using instant trim to get close but it's still not great.

I am using models that started from a sample model downloaded from rcsettings.com which I'm thinking might be part of the problem. I need to start a model from scratch and see if it's different. However even if that works I have tons of trick stuff setup and would rather just find the setting to change rather than toss the models that I've got everything just about perfect on.

Thanks!

User avatar
Kilrah
Posts: 11108
Joined: Sat Feb 18, 2012 6:56 pm
Country: Switzerland

Re: Trims don't actually change servos - Horus/Opentx 2.2

Post by Kilrah »

Trims are assigned in Inputs and Flight Modes.
Stumpthumper
Posts: 1
Joined: Mon Nov 20, 2017 11:38 am
Country: -

Re: Trims don't actually change servos - Horus/Opentx 2.2

Post by Stumpthumper »

Did you find out why the trims act like this? I have the same problem.

Post Reply

Return to “openTx for FrSky radios”