Hi,
I built a openXsensor with a vario and a ACS758 current sensor. The current is transmitted by default and works fine. What do I have to do in oXs_config.h to transmit the consumed milliah?
Thanks for your help.
ACS758 with oXs 8 and FrSky
Moderator: rainer
Re: ACS758 with oXs 8 and FrSky
In Frsky protocol, this value is normally not sent to the Tx because it should be calculated on Tx side.
If you use e.g. openTx 2.2.x I think you have to create a calculated field in telemetry screen (see doc about openTx for more explanations)
If you use e.g. openTx 2.2.x I think you have to create a calculated field in telemetry screen (see doc about openTx for more explanations)
Re: ACS758 with oXs 8 and FrSky
You should say what firmware you are using so you might get better help
João
Sent from my thor using Tapatalk
João
Sent from my thor using Tapatalk
My er9x/Ersky9x/eepskye Video Tutorials
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9
Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
Re: ACS758 with oXs 8 and FrSky
@mstrens:
ah, ok, I see. I created a calculated field. Works very well. Thanks!
@João:
I use oXs v8.0 and on TX side openTX v2.2.0
ah, ok, I see. I created a calculated field. Works very well. Thanks!
@João:
I use oXs v8.0 and on TX side openTX v2.2.0