ACS758 with oXs 8 and FrSky

Development & General Chat for the superb openxvario project.

Moderator: rainer

Post Reply
JayPi01
Posts: 14
Joined: Mon Jan 02, 2012 8:52 am
Country: -

ACS758 with oXs 8 and FrSky

Post by JayPi01 »

Hi,

I built a openXsensor with a vario and a ACS758 current sensor. The current is transmitted by default and works fine. What do I have to do in oXs_config.h to transmit the consumed milliah?

Thanks for your help.

mstrens
Posts: 1435
Joined: Fri Dec 27, 2013 7:49 pm
Country: -

Re: ACS758 with oXs 8 and FrSky

Post by mstrens »

In Frsky protocol, this value is normally not sent to the Tx because it should be calculated on Tx side.
If you use e.g. openTx 2.2.x I think you have to create a calculated field in telemetry screen (see doc about openTx for more explanations)
User avatar
jhsa
Posts: 19480
Joined: Tue Dec 27, 2011 5:13 pm
Country: Germany

Re: ACS758 with oXs 8 and FrSky

Post by jhsa »

You should say what firmware you are using so you might get better help ;)

João

Sent from my thor using Tapatalk

My er9x/Ersky9x/eepskye Video Tutorials
https://www.youtube.com/playlist?list=PL5uJhoD7sAKidZmkhMpYpp_qcuIqJXhb9

Donate to Er9x/Ersky9x:
https://www.paypal.com/cgi-bin/webscr?cmd=_s-xclick&hosted_button_id=YHX43JR3J7XGW
JayPi01
Posts: 14
Joined: Mon Jan 02, 2012 8:52 am
Country: -

Re: ACS758 with oXs 8 and FrSky

Post by JayPi01 »

@mstrens:

ah, ok, I see. I created a calculated field. Works very well. Thanks!

@João:

I use oXs v8.0 and on TX side openTX v2.2.0

Post Reply

Return to “OpenXVario - an open source vario supported by the open source firmwares!!”