Page 1 of 1

Change the SerialTX pin to 0 or 1?

Posted: Sat Mar 18, 2017 8:36 am
by McFly2000
How can I change the TX-Pin to 0 or 1? If I try this in the oXs_config it came the error message "This PIN is not supported".

Re: Change the SerialTX pin to 0 or 1?

Posted: Sat Mar 18, 2017 8:41 am
by Kilrah
The hardware serial port is tied to a particular pin, you can't change it.

Re: Change the SerialTX pin to 0 or 1?

Posted: Sat Mar 18, 2017 8:59 am
by McFly2000
I mean the pin which transmits the serial data to the telemetry receiver (usually 4 or 2). Is this also tied to particular pin?

Re: Change the SerialTX pin to 0 or 1?

Posted: Sat Mar 18, 2017 9:07 am
by Kilrah
As the comment in config.h says it can be either 4 or 2 but no other.