Adhesion to Heated Print Bed (CR10 3D Printer)
Posted: Tue May 01, 2018 12:01 pm
Difficulty getting your 3D Print to sticking to your Print Bed ?
If and when you are having difficulty with your 3D print sticking to Print Bed,
there are many things which can cause this problem, which some are:
1) Printing Z-Gap between Nozzle and Print Bed is improper.
2) Print Bed not level (Tramming) (http://openrcforums.com/forum/viewtopic ... 85&t=10815).
3) Print Bed surface is dirty (with oil and debris).
4) Print Bed surface does not have the proper printing temperature setting.
5) Different band of filament.
6) Moisture in filament.
7) Using a poor quality band of filament.
8) Bad Gcode.
9) 3D SLICER program needs its settings made proper to correct bad writen Gcode.
10) Broken Hardware.
11) Failed hardware (worn out and/or not adjusted properly hardware.
12) Bad build surface (no to little adhesion to printing surface).
--------------------------------------------------------------------------------------------------------------------
I have been trying many of the common fixes or methods to obtain Proper Print Bed Adhesion.
1) tape
2) glue stick
3) hair spray
4) stick on build surface
--------------------------------------------------------------------------------------------------------------------
Yesterday I tried something new and it seem to be working very well.
3D Carbon Fiber Vinyl Adhesive Wrap For Car 1500 X 300 mm Sticker Self Adhesive:
(https://www.ebay.com/itm/323221113409)
If and when you are having difficulty with your 3D print sticking to Print Bed,
there are many things which can cause this problem, which some are:
1) Printing Z-Gap between Nozzle and Print Bed is improper.
2) Print Bed not level (Tramming) (http://openrcforums.com/forum/viewtopic ... 85&t=10815).
3) Print Bed surface is dirty (with oil and debris).
4) Print Bed surface does not have the proper printing temperature setting.
5) Different band of filament.
6) Moisture in filament.
7) Using a poor quality band of filament.
8) Bad Gcode.
9) 3D SLICER program needs its settings made proper to correct bad writen Gcode.
10) Broken Hardware.
11) Failed hardware (worn out and/or not adjusted properly hardware.
12) Bad build surface (no to little adhesion to printing surface).
--------------------------------------------------------------------------------------------------------------------
I have been trying many of the common fixes or methods to obtain Proper Print Bed Adhesion.
1) tape
2) glue stick
3) hair spray
4) stick on build surface
--------------------------------------------------------------------------------------------------------------------
Yesterday I tried something new and it seem to be working very well.
3D Carbon Fiber Vinyl Adhesive Wrap For Car 1500 X 300 mm Sticker Self Adhesive:
(https://www.ebay.com/itm/323221113409)