On OpenTX, when using high amounts of trim (as you might on a first flight), when the rates are then changed (triple rates set to a switch), this change alters the trim setting.
(Calibration done several times, no improvement)
Horus/OpenTX
Re: Horus/OpenTX
You're doing it wrong - rates should be implemented in INPUTS, not in the mixer. Trim gets processed between the 2.
Re: Horus/OpenTX
Thanks for reply.
I was doing it in Mix along with reversal as if you reverse the Inputs (which it allows) the trim does not reverse with it (as with Taranis).
So, INPUT for Rates/Expo, MIX for reversal?
I was doing it in Mix along with reversal as if you reverse the Inputs (which it allows) the trim does not reverse with it (as with Taranis).
So, INPUT for Rates/Expo, MIX for reversal?
Re: Horus/OpenTX
Well it depends what kind of "reversal", but yes.
-
- Posts: 1
- Joined: Fri Dec 02, 2016 8:25 pm
- Country: -
Re: Horus/OpenTX
In menu internal RF, DSMX only shows channels 1 - 6. Should be 16? Is this a SW bug in opentx 2.2?
Last edited by roadrunneraz on Wed Dec 14, 2016 7:12 pm, edited 1 time in total.
Re: Horus/OpenTX
There should not be any DSMX for Internal...
If you're looking at External, that's for use with the "hack module" made with parts form a DX4/DX5. Those don't support more than 6 channels.
If you're looking at External, that's for use with the "hack module" made with parts form a DX4/DX5. Those don't support more than 6 channels.
-
- Posts: 33
- Joined: Thu Jan 16, 2014 1:17 am
- Country: United States
- Location: Northern California
Re: Horus/OpenTX
One of the great things about OpenTX is you can often get the same result from four different methods, it's also a bit dangerous. You could use MIXES for rates and expo, but the generally accepted way to do things is like this:BadRaven wrote:Thanks for reply.
I was doing it in Mix along with reversal as if you reverse the Inputs (which it allows) the trim does not reverse with it (as with Taranis).
So, INPUT for Rates/Expo, MIX for reversal?
- INPUT screen handles physical controls and modifications to a single control. Rates, expo, etc. go here.
- MIXES are where you map one or more INPUT lines to a channel. If you want a little of down elevator, when you increase the throttle or you doing delta wing mixing, that goes here.
- OUTPUTS are where you do final adjustments to channel values. Subtrim, travel adjusment, center adjustment, go here.