Hi there,
I Ssccessfully flashed my X10 to Open TX today. All worked fine.
Uploaded the models from my X9D (also on 2.2.1)via companion - opened the backed up X9D file, selected all the models and then selected write models to radio. They uploaded and are all selectable on the TX.
However when I plug the USB lead into the X10 (power on) i don't get the 'joystick' or 'USB' choice i did before and the PC, although it makes the boing noise of new hardware being connected, it won't see either the SD or Horus memory ??
I do have a USB symbol on the tx next to the signal strength indicator on the top bar...
I can remove the SD card and plug it into the PC directly and it will read it fine.
The USB cable is the same one i used to flash the X10 to Open tx earlier should be fine
Any ideas as i am not able to connect to companion to back up the model files.
TX powers up with no messages.
Regards
Paul
PC won't read SD card on Horus X10 Open TX
Re: PC won't read SD card on Horus X10 Open TX
USB mode in the radio settings is likely set to Joystick, change it to Storage or Ask.
Re: PC won't read SD card on Horus X10 Open TX
Fantastic - that sorted it
Many thanks.
Many thanks.