Kiss FC setup

erskyTx runs on many radios and upgrade boards
ersky9x was a port of er9x for use on the sky9x board.
Post Reply
thinepa
Posts: 19
Joined: Sun Oct 02, 2016 9:49 pm
Country: -

Kiss FC setup

Post by thinepa »

I'm working on setting up my first Kiss FC build and am having issues with setting up an arm switch/flight mode switch on my turnigy 9x with 9xtreme board.
My setup is a kiss FC with kiss 24a ESC's on a ZMR250 and a D4r-II receiver. I have it wired to use PPM.
Channels 1-4 respond normally on the kiss GUI, but I can't figure out how to set up channel 5 (and/or 6) to control arming and flight modes.

Please Lee in mind that I am a relative novice.
Any help is much appreciated.

thinepa
Posts: 19
Joined: Sun Oct 02, 2016 9:49 pm
Country: -

Re: Kiss FC setup

Post by thinepa »

Ok - I answered my own question. Just had to change my # of channels from 4 to 6 in the protocol section.

I just need to do more exploring.
Post Reply

Return to “erskyTx (was ersky9x)”