Trying to get CH3 to output less than 987pwm
Trying to get CH3 to output less than 987pwm
Hey guys trying to setup a Failsafe on my receiver and I need it to output 975 or lower on channel 3 when signal is lost. I cannot find out how to get the radio to do that. I have tried limits and the mixer I am confused. Can anyone provide some assistance.
- MikeB
- 9x Developer
- Posts: 17990
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Trying to get CH3 to output less than 987pwm
In Model|General, turn extended limits (E.Limits) on. Then you can go to +/- 125%.
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: Trying to get CH3 to output less than 987pwm
Awesome thank you. I was almost doing everything right. I didn't realize you had to enable e limits. Thank you very much