Is there anything at all I could have messed with to make my aileron slow to respond - roll left direction only?
To the right when I release, the craft thrashes air to stop - expected behavior.
When move to the left and release, the craft slides to a stop.
Looking in Mission Planner, right movement response is instant.
Left movement takes 3 screen updates (1/4 sec apart) to get the bar to indicate full response.
Same thing for the throttle.
Does not let me cut when landing.
Still runs powered for a 1/2 second before spinning down.
The latter action is recorded in RCOUT logs.
Same behavior on my HEX as on my Quad.
Controller latency
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Controller latency
Go to the "bars" screen. Do the aileron and throttle bars respond immediately, or are they slow to respond?
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: Controller latency
Complete right roll motion takes time to catch up.
Complete left roll is instant.
Throttle must be a different issue.
All other bars move the same.
Complete left roll is instant.
Throttle must be a different issue.
All other bars move the same.
- MikeB
- 9x Developer
- Posts: 17993
- Joined: Tue Dec 27, 2011 1:24 pm
- Country: -
- Location: Poole, Dorset, UK
Re: Controller latency
Check in the mixer for the aileron channel you haven't accidently got a non-zero value in delay or slow.
Mike.
Mike.
erskyTx/er9x developer
The difficult we do immediately,
The impossible takes a little longer!
The difficult we do immediately,
The impossible takes a little longer!
Re: Controller latency
Thank you sir, got it!.
Slow up set to 1.3
Slow up set to 1.3