Received my G9x v4.2 PCb with SD reader and Gprog. The board is assembled but I have a bundle of connectors with bare wires on the end of the leads. Where is an install manual or youtube video. Spent the night searching and came up with nothing. I will also be adding the aftermarket backlight. That I do have the instructions. Any help would be appreciated. btw this is going in to my Turnegy V2.
Mike
Installing Gruvin9x v4.2
-
- 9x Developer
- Posts: 2764
- Joined: Fri Dec 30, 2011 11:11 pm
- Country: -
Re: Installing Gruvin9x v4.2
The rotary encoders connectors? The speaker connectors? Do you have a photo of what remains in the bag?
Bertrand.
Bertrand.
Re: Installing Gruvin9x v4.2
I have the main board installed with the existing transmitter connectors connected. No problem their. For the rotary encoders - after looking at Cam's pictures of his encoder install - my wires on the 4 wire connect are different. Cam has Black (1), yellow, green, white. I have Black (1), red, white, yellow. He was installing on a v4.1 board, I'm installing on a v4.2 board. I want to be sure that the PCB connections are the same on the both boards. I can figure out the wiring color differences easily enough if the PCB is the same.
As far as the Piezo speaker on the board with the transmitter switch. I see that it is the way for the SD card. I saw Cam's solution for changing the position, not an issue. However, can this speaker just be removed since I can plug another speaker into the PCB? Does Open9x use 2 speakers? Or is the speaker that plugs into middle right of the PCB a different kind? If so,what do I need to get from my local electronic part store? Also, where do I type of Vibrating motor do I look for?
As far as the Piezo speaker on the board with the transmitter switch. I see that it is the way for the SD card. I saw Cam's solution for changing the position, not an issue. However, can this speaker just be removed since I can plug another speaker into the PCB? Does Open9x use 2 speakers? Or is the speaker that plugs into middle right of the PCB a different kind? If so,what do I need to get from my local electronic part store? Also, where do I type of Vibrating motor do I look for?
-
- 9x Developer
- Posts: 2764
- Joined: Fri Dec 30, 2011 11:11 pm
- Country: -
Re: Installing Gruvin9x v4.2
Today open9x doesn't drive the piezo speaker on gruvin9x board. But Bryan has asked to add its support. Have a look to the issue he created there:
http://code.google.com/p/open9x/issues/detail?id=64
Still not done. So today no piezzo.
Bertrand.
http://code.google.com/p/open9x/issues/detail?id=64
Still not done. So today no piezzo.
Bertrand.
Re: Installing Gruvin9x v4.2
Any news on this issue?bertrand35 wrote:Today open9x doesn't drive the piezo speaker on gruvin9x board. But Bryan has asked to add its support. Have a look to the issue he created there:
http://code.google.com/p/open9x/issues/detail?id=64
Still not done. So today no piezzo.
Bertrand.
-Fritz