throttle hold curve

Post Reply
heliphil
Posts: 45
Joined: Thu Apr 26, 2012 2:35 pm
Country: -

throttle hold curve

Post by heliphil »

Hi

It seems that there is no separate throttle hold pitch curve and it uses the current pitch from Idle up 0,1 or 2 - Have I missed something as its not what I am used to with my old Futaba radio

User avatar
gohsthb
Posts: 1412
Joined: Wed Dec 28, 2011 2:32 pm
Country: -
Location: Naperville, IL

Re: throttle hold curve

Post by gohsthb »

Personally I use the idle up pitch curves which is -100 to 100. You can set up a separate pitch curve for throttle hold if you want to. You could do it like below:

Pitch channel
+100% THR Switch(ID0) Curve(C1) ** Normal mode curve here
+100% THR Switch(!ID0) Curve(C2) ** Idle up curves here
R100% THR Switch(THR) Curve(C3) ** this would be the curve used in throttle hold, Note this has to be a replace mix

-Gohst
heliphil
Posts: 45
Joined: Thu Apr 26, 2012 2:35 pm
Country: -

Re: throttle hold curve

Post by heliphil »

I did try that ( including replace) but it still used the Idle curve - will try again later to see if I can get it to work - does the order of mixes affect this ???
User avatar
gohsthb
Posts: 1412
Joined: Wed Dec 28, 2011 2:32 pm
Country: -
Location: Naperville, IL

Re: throttle hold curve

Post by gohsthb »

If you have replace mixes, the lowest one in the list has priority. This is on a per output channel basis.
-Gohst
heliphil
Posts: 45
Joined: Thu Apr 26, 2012 2:35 pm
Country: -

Re: throttle hold curve

Post by heliphil »

that was it then - all works fine now

Post Reply

Return to “Helicoptor Programming”