Hi,
is there a firmware update or mod that enables the "new" failsafe option 2 (stop outputting PWM if signal lost) on the D8R V2?
The default is "freeze" the last position and otherwise it can only do option 1 - set all channels to predefined values. Both are kinda bad with an APM...
-Stefan
D8R V2 failsafe
Re: D8R V2 failsafe
AFAIK "option 2" has always been there like on the newer receivers, it simply wasn't documented. Just set failsafe with the radio off.
Re: D8R V2 failsafe
My D8R V2 doesn't react to the button if the TX is off... Already tried .
I currently do it so that I set failsafe on Ch8 so that RTL is active but that's not optimal. I guess, I should get newer RXes then...
I currently do it so that I set failsafe on Ch8 so that RTL is active but that's not optimal. I guess, I should get newer RXes then...
Re: D8R V2 failsafe
Could I ask why you want the reciever to give no pulse output as a failsafe?
Re: D8R V2 failsafe
So my APM knows...