Frysky sensor hub questions
Frysky sensor hub questions
ON the Frysky sensor hub. there is a connector for the power to go into the hub. for rx like a D4R-II, that means I have to do a split from the servo port to supply power to the hub. Is there a way to supply the hub power through one of the sensor connection to the hub? the D4R-II 's side port (G, AD2, +,-) which also has a red wire, I tried but it does not seem to work.
Re: Frysky sensor hub questions
I don't believe there is a power source in the side ports. So you have to use a y-harness or a spare servo connection to power the hub.
-Gohst
-Gohst
Re: Frysky sensor hub questions
The D4RII's side port is Gnd, A2, TX, RX (order probably wrong). No power.
Re: Frysky sensor hub questions
no wonder I tried switching the red wire with no result. OK, I will do a Y harness. thought I may get away with that.
Kilrah: the 4 way switch worked for Sky9x board ppm16. Just finished it last night. but for stock board, still need to be verified. with the trainer port in play that just noodled up my brain. stock board is trickier. May be I should put the schematic up here to poke every one's brain a little.
Kilrah: the 4 way switch worked for Sky9x board ppm16. Just finished it last night. but for stock board, still need to be verified. with the trainer port in play that just noodled up my brain. stock board is trickier. May be I should put the schematic up here to poke every one's brain a little.