9X FrSKY Sensor Hub Telemetry

[ademczuk]

Has anyone managed to pull the Telemetry data from the FrSKY Sensor Hub onto their 9x? I'm using a ERsky9x which doesn't have support for it out of the box and a quick search has not revealed any sample projects so I've come here.
I am hoping to use the temperature sensor, RPM, GPS and Variometer but could do with a leg-up, understanding that a PDF is already out there.

[MikeB]

FrSky telemetry, including hub data, is in ersky9x. You just need to connect the serail data from the Tx module to the serial port on the ersky board.

Mike.

[ademczuk]

Perhaps I flicked the FrSky reciever switch or have put the cable round the wrong way because when I connect the temperature sensor I don't see where in ersky9x the reading should be output. So far I can only see an area for voltage. I have connected the sensor hub to A1, should I connect it to A2.

[Kilrah]

The sensor hub must be connected to the DATA port (G TX RX).

[ademczuk]

Oh right. the one that the jumper on it. thanks
Is there a section for amps and x y z variometer?

Sent from my GT-P1000 using Tapatalk 2

[Kilrah]

The jumper should actually be on either A1 or A2 if you want to measure the receiver's supply voltage with that input.

Yes all hub values can be displayed AFAIK.